How to apply your bespoke standoff artwork to your wall

When it comes to hanging your office wall signs or custom artwork, standoffs are the best sign hardware out there to make your artwork pop out from the wall and create a 'wow' factor feature wall.

What is a Standoff?

A standoff is a small piece of hardware that attaches to a sign and secures it to the wall. Standoffs are made up of a barrel, cap, and wall screw. Standoffs allow signs or artwork to actually 'stand off' from the wall. This helps to create an attention-getting 3D effect around the artwork.


To Apply your artwork you will need:

- Pencil

- Rubber (if making a lot of lines)

- Spirit level

- Screwdriver

- Raw plugs

How to Assemble Sign Standoffs:

  1. Measure your sign and mark the wall where the wall screws will go - use a level to make sure the sign will be perfectly straight.

  2. Drill pilot holes where marked using a drill bit that's slightly smaller than the width of the supplied wall screw. TIP: Pre-drill your pilot holes for accuracy.

  3. Take your standoff and unscrew the cap from the barrel.

  4. Screw the wall screw through the bottom of the barrel and into the pilot hole - do this for all the holes in your sign.

  5. Line up your signage with the barrels on the wall so that the holes in your sign are right over the barrels.

  6. Screw the caps through the signage and into the barrels - this will secure the sign in place.

  7. Stand back and admire your new wall art.

  8. Send us a photo of you next to your new Office Wall Art!



Need further help?

Still not sure what to do? Have some questions? Just ask us. We would rather you ask the question before you drill the hole.


Phone: 01476 245053

Email: info@officewallart.co.uk

Website: www.offocewallart.co.uk


If you feel these instructions are not thorough enough, or could be better presented, please email us and let us know so we can better our service for future users to the Office Wall Art Knowledge Centre. Thank you.

Email: info@officewallart.co.uk